Faber Appliance Repair in Quedgeley Fieldcourt

Why is my Faber cooker hood not extracting properly?

Reduced extraction on a Faber cooker hood is usually caused by clogged filters, blocked ducting, or stuck damper flaps. Clean the grease filters thoroughly, replace charcoal filters for recirculation hoods, check the exterior vent for blockages, and ensure ducting is not kinked. If suction remains weak, contact a qualified technician.

Why is my Faber cooker hood making excessive noise or vibrating?

Excessive noise or vibration from a Faber cooker hood is commonly caused by incorrect installation, undersized ducting, or a loose mounting. Verify the hood is securely fixed and that ducting maintains the recommended diameter throughout the entire run without kinks or restrictions. Dirty filters can also increase noise levels. If vibrations persist after checking installation, contact a qualified technician as the motor or impeller may require inspection.

Why is my Faber cooker hood motor humming but not spinning?

If your Faber cooker hood motor hums but the fan does not spin, this typically indicates a faulty start capacitor or a seized motor. Switch off the hood at the mains immediately and do not continue using it in this condition. Symptoms may vary by model, so consult your instruction manual for model-specific guidance. Contact a qualified technician for diagnosis and repair.

Why are all LED buttons flashing twice on my Faber cooker hood?

When all LED buttons flash twice simultaneously on a Faber cooker hood, it indicates that the control lock mode has been activated or deactivated. This safety feature prevents accidental changes to hood settings during cleaning. To toggle the lock, press and hold the designated button according to your model's instructions. This is a confirmation signal, not an error.

Why are the lights not working on my Faber cooker hood?

If the lights on your Faber cooker hood do not illuminate but the motor works, it may be a bulb, LED strip, or driver failure. Switch off at the mains before any inspection. For halogen models, you may check and replace the bulb with a matching type, avoiding direct skin contact with the new bulb. For LED models, contact a qualified technician as LED components require technical expertise to replace. Consult your instruction manual for model-specific bulb specifications.

What is the Faber Long Lasting charcoal filter and how do I maintain it?

The Long Lasting filter is a reusable active carbon filter with multi-layer technology that can be washed in the dishwasher every 3-4 months and lasts for up to 3 years of normal use. After washing, dry it at room temperature in a vertical position or in an oven at 50°C.

What is the 24-hour air circulation mode on Faber cooker hoods?

The 24-hour air circulation mode is an eco-friendly feature that runs the hood at very low speed to maintain continuous fresh air exchange in your kitchen. When activated, the hood operates briefly at regular intervals throughout the day, typically below 40 dB(A), with minimal energy consumption.

What is K-Link technology on Faber cooker hoods?

K-Link is Faber's wireless technology that connects compatible Faber induction hobs and cooker hoods using radio signals. When enabled, the hood automatically adjusts its extraction power based on the cooking intensity of the hob, optimising performance without manual adjustment while reducing energy waste and unnecessary noise.

What are the benefits of LED lighting in Faber cooker hoods?

LED lighting in Faber cooker hoods provides bright, even illumination across the entire cooking area while using significantly less energy than traditional halogen bulbs. LEDs also have a much longer lifespan and produce less heat, contributing to the overall energy efficiency of the hood.

What does the flashing light on my Faber cooker hood mean?

A flashing light on a Faber cooker hood typically indicates a filter maintenance alarm. A steady or slow-flashing light signals that the grease filters need cleaning (activated after approximately 100 hours of use), while a faster flash indicates the charcoal filters need replacing (activated after approximately 200 hours).