Faber Appliance Repair in Kingsholm and Wotton

Why are all LEDs flashing three times on my Faber cooker hood?

When all LEDs flash three times simultaneously on a Faber cooker hood, it confirms that the filter saturation alarm has been successfully reset. This is a confirmation signal, not an error, and no action is required.

Why are the control panel buttons not responding on my Faber cooker hood?

Control panel buttons not responding on a Faber cooker hood may be caused by grease buildup, loose cable connections, or a faulty control board. Switch off at the mains, clean the control panel with a soft damp cloth, and leave unplugged for 10 minutes to reset. Symptoms may vary by model, so consult your instruction manual for model-specific guidance. If the issue persists, contact a qualified technician.

Why are the lights not working on my Faber cooker hood?

If the lights on your Faber cooker hood do not illuminate but the motor works, it may be a bulb, LED strip, or driver failure. Switch off at the mains before any inspection. For halogen models, you may check and replace the bulb with a matching type, avoiding direct skin contact with the new bulb. For LED models, contact a qualified technician as LED components require technical expertise to replace. Consult your instruction manual for model-specific bulb specifications.

Why is my Faber cooker hood making excessive noise or vibrating?

Excessive noise or vibration from a Faber cooker hood is commonly caused by incorrect installation, undersized ducting, or a loose mounting. Verify the hood is securely fixed and that ducting maintains the recommended diameter throughout the entire run without kinks or restrictions. Dirty filters can also increase noise levels. If vibrations persist after checking installation, contact a qualified technician as the motor or impeller may require inspection.

What does a flashing LED light mean on a Faber cooker hood?

A flashing LED light on a Faber cooker hood signals that the activated charcoal filter needs replacing. This alarm appears after approximately 200 hours of operation in recirculation mode. Replace the charcoal filter with a genuine Faber replacement and clean the grease filters, then reset the alarm according to your model's instructions.

When should I turn on my Faber cooker hood?

Turn on your cooker hood at least one minute before you start cooking. This allows proper air circulation to be established before cooking vapours and odours are produced.

Why is my Faber cooker hood remote control not working?

First check whether the batteries need replacing and install fresh CR2032 batteries if necessary. If this does not solve the problem, the remote control receiver on the hood may be deactivated and needs to be reactivated through the hood's control panel.

Is grease on the filters a fire hazard?

Grease deposited on filters is inflammable, which is why regular maintenance is essential. Clean or replace filters according to the recommended schedule based on approximately 3 hours of daily use. Never allow excessive grease to accumulate on the filters.

How do I find the model and serial number of my Faber cooker hood?

The model and serial number of your Faber cooker hood are printed on the label located inside the hood. To access this label, switch off the hood at the mains, then remove the grease filters to reveal the white identification label underneath.

Where can I find the user manual for my Faber cooker hood?

User manuals for Faber cooker hoods are available on the individual product pages on the Faber UK website. Locate your hood model and download the manual in PDF format from the product page.