Faber Appliance Repair in Barton and Tredworth

Why are the control panel buttons not responding on my Faber cooker hood?

Control panel buttons not responding on a Faber cooker hood may be caused by grease buildup, loose cable connections, or a faulty control board. Switch off at the mains, clean the control panel with a soft damp cloth, and leave unplugged for 10 minutes to reset. Symptoms may vary by model, so consult your instruction manual for model-specific guidance. If the issue persists, contact a qualified technician.

Why are all LED buttons flashing twice on my Faber cooker hood?

When all LED buttons flash twice simultaneously on a Faber cooker hood, it indicates that the control lock mode has been activated or deactivated. This safety feature prevents accidental changes to hood settings during cleaning. To toggle the lock, press and hold the designated button according to your model's instructions. This is a confirmation signal, not an error.

Why is my Faber cooker hood motor humming but not spinning?

If your Faber cooker hood motor hums but the fan does not spin, this typically indicates a faulty start capacitor or a seized motor. Switch off the hood at the mains immediately and do not continue using it in this condition. Symptoms may vary by model, so consult your instruction manual for model-specific guidance. Contact a qualified technician for diagnosis and repair.

Why is my Faber cooker hood making excessive noise or vibrating?

Excessive noise or vibration from a Faber cooker hood is commonly caused by incorrect installation, undersized ducting, or a loose mounting. Verify the hood is securely fixed and that ducting maintains the recommended diameter throughout the entire run without kinks or restrictions. Dirty filters can also increase noise levels. If vibrations persist after checking installation, contact a qualified technician as the motor or impeller may require inspection.

Why are the lights not working on my Faber cooker hood?

If the lights on your Faber cooker hood do not illuminate but the motor works, it may be a bulb, LED strip, or driver failure. Switch off at the mains before any inspection. For halogen models, you may check and replace the bulb with a matching type, avoiding direct skin contact with the new bulb. For LED models, contact a qualified technician as LED components require technical expertise to replace. Consult your instruction manual for model-specific bulb specifications.

What is the minimum installation height for a Faber cooker hood above an electric or induction hob?

The minimum distance between the cooker hood and an electric or induction hob is 65cm. If the hob has a larger cooking area, the hood may need to be positioned slightly higher to provide complete coverage.

Why is my Faber cooker hood remote control not working?

First check whether the batteries need replacing and install fresh CR2032 batteries if necessary. If this does not solve the problem, the remote control receiver on the hood may be deactivated and needs to be reactivated through the hood's control panel.

What is the Faber Long Lasting charcoal filter and how do I maintain it?

The Long Lasting filter is a reusable active carbon filter with multi-layer technology that can be washed in the dishwasher every 3-4 months and lasts for up to 3 years of normal use. After washing, dry it at room temperature in a vertical position or in an oven at 50°C.

What does the flashing light on my Faber cooker hood mean?

A flashing light on a Faber cooker hood typically indicates a filter maintenance alarm. A steady or slow-flashing light signals that the grease filters need cleaning (activated after approximately 100 hours of use), while a faster flash indicates the charcoal filters need replacing (activated after approximately 200 hours).

When should I turn on my Faber cooker hood?

Turn on your cooker hood at least one minute before you start cooking. This allows proper air circulation to be established before cooking vapours and odours are produced.