Midea Appliance Repair in Matson, Robinswood and White City

What does the P4 error mean on a Midea split air conditioner?

The P4 error on a Midea split air conditioner indicates an inverter drive error. Turn off at the mains for 10 minutes to reset. If the error persists, contact a qualified technician as the inverter module may require diagnosis.

What does the F1 error mean on a Midea split air conditioner?

The F1 error on a Midea split air conditioner indicates an indoor or outdoor temperature sensor fault with an open or short circuit. Turn off at the mains for 10 minutes to reset. If the error persists, contact a qualified technician for sensor diagnosis.

What does the E7 error mean on a Midea washing machine?

The E7 error on a Midea washing machine indicates a motor directional error where the motor is not rotating in the expected direction. Unplug the machine and wait a few minutes before restarting. If the error continues, contact a qualified technician.

What does the E9 error mean on a Midea washing machine?

The E9 error on a Midea washing machine indicates a pressure sensor error where the water level sensor is not functioning correctly. Unplug the machine for a few minutes, then restart. If the error persists, contact a qualified technician.

What does the F4 error mean on a Midea split air conditioner?

The F4 error on a Midea split air conditioner indicates an EEPROM parameter error in the outdoor unit. Turn off at the mains for 10 minutes to reset. If the error persists, contact a qualified technician as the control board may require diagnosis.

How can I remove odours from my Midea refrigerator?

Store all foods in tightly sealed containers or wrapped properly. Clean the interior with a solution of warm water and bicarbonate of soda. Remove any expired or spoiled food. If odours persist, try placing an open box of bicarbonate of soda inside the refrigerator to absorb smells.

What water temperature should I use for my Midea dishwasher?

Water entering the dishwasher should be between 50 and 65 degrees Celsius for optimal cleaning. Always connect the dishwasher to the hot water supply, not the cold. If dishes are not getting clean, run the hot tap at the kitchen sink before starting a cycle to ensure hot water reaches the dishwasher from the start.

How do I clean the base filter on my Midea heat pump tumble dryer?

The base filter located in front of the heat exchanger should be cleaned after every fifth drying programme. Remove the filter, clean any accumulated lint, rinse with water if heavily soiled, and ensure it is completely dry before reinstalling.

How do I set up continuous drainage on my Midea portable air conditioner?

Remove the drain plug from the back of the unit and attach a 3/4 inch hose to the drain connector. Ensure the hose maintains a downward slope throughout its entire length to allow gravity drainage. Place the open end over a suitable drain.

What should I do if my Midea tumble dryer overheats?

The most common cause of overheating is a blocked lint filter. Clean the lint filter immediately. Allow the dryer to cool for at least ten minutes before attempting to restart. Some models have a safety reset button on the back panel that can be pressed with a finger or pencil. If overheating continues, contact a qualified technician.